| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Engine/Hybrid System | Section: Emission Control | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000029Q500AX |
| Title: 2UZ-FE EMISSION CONTROL: AIR SWITCHING VALVE: INSPECTION (2008 Sequoia) | ||
INSPECTION
1. INSPECT AIR SWITCHING VALVE ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
1 - 5 |
20°C (68°F) |
4.5 to 5.5 Ω |
|
1 - Body ground |
Always |
1 MΩ or higher |
|
5 - Body ground |
NOTICE:
When measuring the resistance, do not touch terminals 2, 3, and 4.
If the result is not as specified, replace the air switching valve assembly.
|
(b) Check operation of the air switching valve assembly. (1) Check that air does not flow from port A to port B. NOTICE:
Make sure that the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less. If the result is not as specified, replace the air switching valve assembly. (2) Apply battery voltage across terminals 1 and 5. NOTICE:
When applying voltage, do not touch terminals 2, 3, and 4. (3) Check that air flows from port A to port B. If the result is not as specified, replace the air switching valve assembly. |
|
|